danis_node
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| danis_node [2025/09/24 23:59] – river | danis_node [2025/09/25 00:32] (current) – river | ||
|---|---|---|---|
| Line 24: | Line 24: | ||
| I measured when running meshtastic 2.6.11 from supplied image, LEDs disabled, not transmitting. | I measured when running meshtastic 2.6.11 from supplied image, LEDs disabled, not transmitting. | ||
| + | |||
| + | I think I used a different nRF board from the one Dani supplied. They look very similar, but this one says C3 on the aerial chip. | ||
| Supplied on battery terminals: | Supplied on battery terminals: | ||
| Line 32: | Line 34: | ||
| 5V supplied on USB port: | 5V supplied on USB port: | ||
| - | Between | + | 9.55mA or 10.05mA, with bluetooth connected or not respectively. Blue LED flashes rapidly. |
| - | + | ||
| - | Current draw reduces by about 600uA from these numbers when connected to phone by bluetooth, which happened about 35 seconds after power on. | + | |
| + | 3.3V on USB port: | ||
| + | 9.49mA. Same with bluetooth connected. LED not flashing. | ||
| + | Current draw reduces by about 600uA from these numbers when connected to phone by bluetooth, which happened about 35 seconds after power on. | ||
danis_node.1758758370.txt.gz · Last modified: by river